ABSTRACT
Abstract-Fluorocarbon radio-frequency glow-discharge (RFGD) treatment has previously been shown to cause decreased platelet adhesion despite the presence of adsorbed fibrinogen on the surfaces. In this study platelet adhesion to fluorocarbon RFGD-treated surfaces preadsorbed with human plasma was further examined. A series of plasma deposited fluorocarbon thin films were made by varying the C3F6/CH4 ratio in the monomer feed. The surfaces were preadsorbed with plasma, serum, or plasma selectively depleted of fibronectin, vitronectin, or Von Willebrand factor, and platelet adhesion was measured. We also measured fibrinogen adsorption to the surfaces from plasma, monoclonal antibody binding to adsorbed fibrinogen and SDS elutability of the adsorbed fibrinogen. The antibodies used bind to the three putative platelet binding sites on fibrinogen, namely, Ml antibody binds to the dodecapeptide at the C-terminus of the gamma chain, y(402^-11), Rl antibody binds to a sequence in the Aa chain (87-100) which includes RGDF at Aa(95-98) and R2 antibody binds a sequence in the Aa chain (566-580) which includes RGDS at Aa(572-575). Fibrinogen was found to play a decisive role in mediating platelet adhesion to the fluorocarbon surfaces contacting plasma. Few platelets adhered to the fluorocarbon surfaces preadsorbed with serum, while preadsorption with plasma selectively-depleted of either fibronectin, vitronectin, or von Willebrand factor did not decrease platelet adhesion significantly. Replenishment of exogenous fibrinogen to serum restored platelet adhesion, while replenishment of the other proteins had no effect. Platelet adhesion to the fluorocarbon surfaces was lower than to PET or the methane glow-dischargetreated PET. However, there was no apparent correlation between platelet adhesion and the amount of fibrinogen adsorption or monoclonal antibody binding to surface-bound fibrinogen.
